Tricks of the Trade: Make a Quick Infeed Table

I needed to cut long boards on the table saw, but had only a small table for the outfeed and none for the infeed. So I built this handy infeed table using scrap plywood and a sawhorse, both of which I already had on hand. I drilled a hole in the center of the sawhorse crossbar and cut a slot in the plywood. The ply is fastened to the horse […]

The post Tricks of the Trade: Make a Quick Infeed Table appeared first on Popular Woodworking Magazine.

Share This:

This entry was posted in Uncategorized. Bookmark the permalink.

Leave a Reply

Your email address will not be published. Required fields are marked *